DSP-Verstärker für Subwoofer
Sinbosen Touchscreen DSP-Modul Leistungsverstärker DSP22000q Professioneller DSP-Verstärker
punkt nr.: DSP-22Q
Modell: DSP22000Q
Kanal: 4-Kanal-Leistungsverstärker
Ausgangsleistung:
8Ω Stereoleistung (RMS): 2.500W X 4CH
4Ω Stereoleistung (RMS): 4.650W X 4CH
Klasse: TD
Zertifizierung: CE, ROHS, TÜV
Garantie: 3 Jahre
Sonderservice: OEM-Service angeboten
Kanal: 4-Kanal-Leistungsverstärker
Ausgangsleistung:
8Ω Stereoleistung (RMS): 2.500W X 4CH
4Ω Stereoleistung (RMS): 4.650W X 4CH
Klasse: TD
Zertifizierung: CE, ROHS, TÜV
Garantie: 3 Jahre
Sonderservice: OEM-Service angeboten
beschreibung
| DSP22000Q | |||||||
| 8 ohm Stereo Power (RMS) | 2500WX4 | ||||||
| 4 ohm Stereo Power (RMS) | 4650WX4 | ||||||
| 8 ohm Bridged Power (RMS) | 9500WX2 | ||||||
| 4 ohm Bridged Power (RMS) | 23750WX2 | ||||||
| Frequency Response(+o/-0.3dB,1W/8Ω): | 20 Hz - 34 kHz | ||||||
| THD 20 Hz - 20 kHz for 1W: | <0.1% | ||||||
| Signal-to-Noise Ratio: | >112 dBA | ||||||
| Channel separation (Crosstalk) at 1 kHz : | >70 dB | ||||||
| Input Connectors (per channel): | 3 pin XLR, electronically balanced | ||||||
| Output Connectors (per channel): | Binding Posts 2-pole | ||||||
| Class: | TD | ||||||
| TourClass Protection: | ACL, IGM, AutoRamp, short circuit, DC voltage, turn on/off transient, current inrush, sub/ultrasonic input | ||||||
| Operating voltage, 220V / 110V nominal: | 180-240 V / 90-130 V selectable | ||||||
| Voltage Gain(dB): | 23, 26, 29, 32, 35, 38, 41, 44 dB selectable | ||||||
| Input impedance: | 20 kOhm | ||||||
| Level adjustment (per ch.): | Front panel potentiometer, 31 positions detented from -inf to 0 dB | ||||||
| Software control |
Multiple power amplifier controls | Touch screen |
Amplifier built-in processor,4 inch size led screen can touch,control the amplifier sound effect |
DSP amplifier also cintrol by PC,through software can more precise adjustment dsp processor | One PC can independent control serveral dsp amplifier at the same time |
Capacitor Upgrade
The old one is 3300UF 200V and now the new is 3600UF 200V. Totally add more 300UF capacity. The amplifier power supply board is better than before, it will make your subwoofer bass sound quality more loud and powerful.
New cooling system
We upgrade cooling system, added 8 fans on the rear panel. Enhance the heat dissipation capability of the amplifier.
4-Kanal Class TD Schaltverstärker mit DSP
4 x 4.650 Watt an 4 Ohm, 4 x 2.500 Watt an 8 Ohm
Erstellen Sie SUPER Klangqualität
Steuern Sie den Soundeffekt per Touch auf dem vorderen 4" LED-Display
Oder steuern Sie den Soundeffekt per Computer
Einfache DSP-Software, keine Installation erforderlich, einfache Bedienung
Bridge-Modus-Betrieb für Touring-Anwendungen
Umfassendes Schutzsystem
Verwenden Sie den Original-ONSEMI-Transistor
Neutrik XLR*/Speakon-Anschlüsse
4 x 4.650 Watt an 4 Ohm, 4 x 2.500 Watt an 8 Ohm
Erstellen Sie SUPER Klangqualität
Steuern Sie den Soundeffekt per Touch auf dem vorderen 4" LED-Display
Oder steuern Sie den Soundeffekt per Computer
Einfache DSP-Software, keine Installation erforderlich, einfache Bedienung
Bridge-Modus-Betrieb für Touring-Anwendungen
Umfassendes Schutzsystem
Verwenden Sie den Original-ONSEMI-Transistor
Neutrik XLR*/Speakon-Anschlüsse
Note:
Full-range speaker [line array speaker, professional speaker]: the power of the power amplifier should be greater than 1.5 times or more;
Subwoofer speaker: The power of the amplifier should be more than 2 times or more, because the current of the low frequency speaker is larger than that of the full frequency speaker!
 |
 |
 |
 |
 |
 |
